When to call
Problems we help diagnose
- Furnace will not start or produce heat
- Ignition, flame-sensor and burner faults
- Blower, airflow, filter and limit problems
- Short cycling or repeated lockouts
- Unusual noises, smells or intermittent operation
Heating service
Furnace Repair & Service
When a furnace stops heating, the fault may be in the thermostat signal, inducer, ignition, gas valve, flame proving, blower, airflow or safety circuit. We follow the sequence of operation, test the stage that failed and explain the repair in plain language.
Red SealPlumber-led service
Class BGas fitter
$5 millionLiability insured
1 yearWorkmanship warranty
What is included
A clear, practical service visit
- Sequence-of-operation diagnosis
- Thermostat, electrical and control testing
- Ignition, flame-proving and safety checks
- Blower and airflow assessment
- Repair and equipment-lifecycle recommendations
How it works
From the first call to a clear next step.
01
Confirm the call for heat and operating sequence
02
Test the failed stage or component
03
Repair when approved and verify a full heating cycle
A furnace repair should follow the operating sequence
Replacing a part without confirming why the cycle stopped can miss the real problem. We verify the call for heat and work through the inducer, pressure proving, ignition, gas, flame signal and blower stages as applicable to the equipment.
Ignition and flame faults
Diagnosis of igniters, flame sensors, gas-valve operation and related controls when the burner will not remain lit.
Airflow and limit trips
Filters, blower operation, coil condition and airflow restrictions can cause overheating and repeated shutdowns.
Controls and electrical
Thermostat signals, low-voltage circuits, switches, motors and control-board operation are tested before conclusions are made.
No-heat service for homes and managed properties
We support residential furnaces as well as equipment serving strata and light-commercial properties. Service documentation separates the immediate repair from maintenance or future replacement considerations.
Emergency no heat
24/7 availability when the furnace stops during cold weather or repeated faults leave the property without heat.
Intermittent problems
Fault history and operating observations help diagnose equipment that starts, stops or locks out unpredictably.
Repair-first guidance
We explain the confirmed failure and consider equipment condition before recommending replacement.
Service questions
Answers before you call.
Why is my furnace running but not producing heat?
The blower may run even when ignition, gas flow or flame proving has failed. Thermostat settings and airflow can also contribute. The heating sequence must be tested to identify the failed stage.
What causes a furnace to short cycle?
Possible causes include airflow restriction, limit trips, thermostat or control issues, flame-signal problems and equipment sizing. Repeated cycling should be diagnosed rather than continually reset.
Do you provide emergency furnace repair?
Yes. We offer 24/7 emergency no-heat availability across our service area. Call with the furnace brand, visible fault code and symptoms if available.
Should I repair or replace an older furnace?
That depends on the confirmed fault, repair cost, equipment condition, reliability and efficiency. We provide the repair option when practical and explain when replacement deserves consideration.
Areas served
Furnace repair across Metro Vancouver.
Choose your city for local service information, common property types and the quickest way to request help.
Request service
Tell us what's happening.
Call first for the quickest response. For non-urgent work, send the short form and include the best number to reach you.
778-712-1209